Replacing a Probe Tip

To Remove the Old Tip
	1) Pull up on the upper arm until the tip is completely withdrawn from the sleeve.
	2) Rotate the tip until the end (with 90 degree bend) aligns with the slot in the upper arm and comes free.

To Add the New Tip - Reverse the procedure stated in steps 1 & 2 above.
	3) Insert the end (with 90 degree bend) into the slot in the upper arm. Then pull up on the upper arm and rotate the tip until the tip end aligns with the sleeve.
	4) Release the upper arm as you guide the tip to enter the sleeve.

© Copyright Florida Probe Corporation, 1996,1997
This page last updated on Monday, October 27, 1997.